For a visual guide, check out our Set Up Tutorial videos.
Setup steps
Step 1 – Unpack
Remove all components from the box: transmitter/charging station, headphones, power cable, audio cable, batteries, and adapters.
Step 2 – Install batteries
Insert the batteries into the headphones if not pre-installed. Twist the left earpad counterclockwise and lift it off to access the battery compartment.
Step 3 – Connect power
Use the power cable to connect the transmitter/charger to an electrical outlet.
Step 4 – Charge the headphones
The charge indicator light will illuminate to show charging. The headphones usually arrive with some charge, but should be charged for 16 hours initially.
Step 5 – Connect to the audio source
Use the audio cable to connect the transmitter/charger to the audio OUTPUT on your device. Depending on your device, this may be a 3.5mm headphone jack, red and white RCA outputs, or a digital output.
Step 6 – Turn on the audio source
Switch on your TV, stereo, or other audio source.
Step 7 – Power on the headphones
Press and hold the power button on the back edge of the right earcup for 3 seconds. This will also turn on the transmitter. The headphones' LED will blink and the transmitter's LED will light up and stay solid.
Step 8 – Ready to listen
Within a few seconds, the wireless link will establish and you will hear audio.
Note: If you have trouble, ensure all connections are secure and both the transmitter and headphones are powered on.